Description

Introduction

The SMART-LINE data center dedicated intelligent bus system is a dedicated busbar system for the power distribution at the end of the data cabinet, which was carefully developed in three years by Zhenjiang Gardermoen Wisdom Power Technology Co., Ltd. The appearance is exquisite, the installation is simple and convenient, the safety performance is high, and the degree of intelligence is high, completely breaking the traditional cabinet power distribution mode of the distribution column head cabinet and the bridge cable. The SMART-LINE data center dedicated intelligent busbar system produced by Gardermoen has provided an excellent end-distribution system, which can support the rated mains current of the busbar trunk system from 160A to 500A, and the tap-box current is from 10A to 63A. And support the bus system to be grounded separately. At the same time, the advantage of Gardermoen shares is that it supports the power distribution box unit to be fully installed in the case of the entire busbar trunk system charging, plug and play.

Basic Data

• Standard: IEC61439.1/6; GB7251.1/6
• System: AC3P5W(51)；AC3P5W(53);DC Double loop
  
• Ambient Temperature: 5～+40℃.
• The 24-hour average temperature does not exceed+35℃
• IP Rating: IP40
• Ui AC(V): 415V
• Rated Current:160A; 200A; 250A; 315A;400A; 500A;
• PIug-in Box current: 10A; 16A; 20A; 25A; 32A; 40A; 50A; 63A;
• Overall Dimensions: Height × width=154.6×84.6
• The length Of The Standard: 3.0m; 2.4m; 1.8m; 1.2m; 0.6m（Can also be customized according to requirements）

Utility

• Modern digital center room

Plug-in Box Unit

The plug-in box is a necessary part of the busway to send power to the powered device. According to actual needs, the plug-in box can provide single-loop, three-loop and six-loop current. The diversified configuration of the plug-in box realizes the shunting of electric energy, and the three-phase uniform load is ensured to the utmost. According to the actual configuration of the busway, the plug-in box is fully compatible with the three-phase four-wire system and the three-phase five-wire system.

The corresponding circuit breaker is selected inside the plug-in box to cut off the current under fault conditions. All components in the docking box have been assembled and tested at the factory. The internal circuit breakers are installed according to the customer’s designated brand. And has the following

Advantages:

• Multiple configurations (single loop, triple loop, six loop)
• Aluminum alloy profile + plastic composite case, light and light
• Rotating and plugging, saving time and effort, hot plugging
• Error prevention phase device
• Quick locking device
• High purity carbon brush terminal
• Intelligent monitoring module (full electrical parameter and four-point temperature monitoring for each cabinet, and equipped with RS485 communication interface)